Hello. This is Easy&Light !
Today, I'm going to introduce how to charge your iPad while using Twomon SE :)
When you use the dual monitor with the iPad,
Depending on the amount of data usage, battery consumption will vary.
In general, when you use it, your iPad battery is worn out!
So, today's product to use together is...
 |
| NEXT-UH303LAN |
It is a product that allows us to use USB3.0 hub and Giga Ethernet LAN card together!
If you connect the cable using the NEXT 3.0 hub, Twomon SE can be used while charging because it supplies more electricity than USB2.0
Now, let's try a simple test!
(Used device: LG Gram / iPad Pro 10.5)
And it was measured at 0.44A!
when you continued to use Twomon SE in this way, the battery consumption was faster.
So, what if you connect to a NEXT 3.0 hub?
 |
| When connected to a 3.0 hub(with power)
We measured the electric current by connecting the cable to the NEXT 3.0 hub connected to the power.
It was measured at 1.38A!
It was 0.94A higher than when connected directly to the PC.
If you use Twomon SE in this environment, you don't need to worry about battery consumption.
After powering off the hub, I measured the current by connecting a cable to the NEXT3.0 hub.
It was measured at 1.01A.
And 0.37A lower than when it was with power.
but, It is still possible to use while charging.
In addition, I have tested it with ORICO hub products!
However, this ORICO hub must be connected to the power supply.
The ORICO measured 1.34A.
The current of NEXT3.0 hub was 0.04A higher than ORICO.
PC ↔ USB3.0 HUB ↔ Tablet
iPad 11inch / LG Gram device
4.77V, 1.37A
In this environment, the battery change was increased by 4% per hour
and 8% increased in total when I played Youtube videos in full for 2hours.
(Battery 27% → 35%)
If you want to use Twomon SE while charging your tablet,
You can refer to the ways described above :)
Thanks !
|
No comments